Switch 2(config)# interface fastEthernet 0/3 Switch 2(config-if)# switchport access vlan 3 Switch 2(config-if)# switchport mode access Switch 2(config)# interface fastEthernet 0/2 Switch 1# copy running-config startup-configĪfter configuring the first switch, we will configure switch 2 similar to switch 1 as below. Switch 1(config-if)# switchport trunk allowed vlan 2-4 Switch 1(config-if)# switchport nonegotiate Switch 1(config-if)# switchport mode trunk Switch 1(config)# interface fastEthernet 0/1 Switch 1(config-if)# switchport access vlan 3 Switch 1(config)# interface fastEthernet 0/4 Switch 1(config)# interface fastEthernet 0/3

Switch 1(config-if)# switchport access vlan 2

Switch 1(config-if)# switchport mode access Switch 1(config)# interface fastEthernet 0/2 Laslty, we will set the allowed VLANs with “ switchport trunk allowed vlan” command on this trunk and save our configuration.Then we will also set this port with “ no negotiate” command to prevent negotiation about the port role.After that, we will set the trunk port that will carry multiple VLANs with “ swithcport mode trunk” command.We will also set the VLAN, that this port will access.We will do this with “ switchport mode access” command under these interfaces. We will set access ports that will access specific VLANs.These ip addresses will be required at the end of this configuration example to test our configuration.Īfter PC IP configurations, now, we can start our VLAN Packet Tracer Configuration steps. pkt format at the end of the lesson.įor all Packet Tracer Examples and Files, you can check Packet Tracer Labs Page.įor our VLAN Configuration example, we will set our PC IPaddresses as below. Packet Tracer VLAN Topology ExampleYou can DOWNLOAD the Cisco Packet Tracer example with. In this topology, 2 Cisco Catalyst 2950-24 switches and 6 PCs are used. The standard value is UDP port 2055, but other values like 9555 or 9995 can also be used.As an example, you can see a VLAN topology below.

The IP address and the destination UDP port of the NetFlow collector have to be configured on the sending device (router or l3 switch). NetFlow records are exported to a Netflow collector using User Datagram Protocol (UDP). This feature is used by network operators for billing network users. Netflow version 9 was standardized in 2008 as IPFIX by the IETF organization. The data processed by Netflow collectors provides the network administrator with detailled traffic informations such as the source and destination of the traffic, class of service. Netflow is a network analysis protocol that was initially created by Cisco to give the ability to collect detailled informations about network traffic as it flows through a router interface. Packet Tracer 8.0 - Netflow configuration Details Last Updated: Thursday, 08 April 2021 06:12 Published: Tuesday, 16 July 2013 16:10 Written by PacketTracerNetwork

Config cisco ccna example packet tracer